Aiwa JAX-S5 Manuel de service télécharger pdf (Page 18)

CX-JN10

CD TEST MODE

• This mode can run the CD sled motor freely. Use this mode, for

instance, when cleaning the pickup.

Procedure:

1. In the status where AC plug is disconnected, while pressing

the [CD] button, connect the AC plug to turn the power on.

2. When enter this mode, it displays “CD TEST” and few sec-

onds later, all segments turn on of the fluorescent indicator

tube.

3. To release from this mode, disconnect the AC plug and turn

the power off.

In this mode, it operates as following table.

Button Operation Purpose of use

M Move the pick-up to outside track Sled circuit check

m Move the pick-up to inside track Tracking circuit check

Mechanism operation check

Optical pick-up check

N Playback a CD Servo block check

If it cannot focus on, it continuous focus search

x When playback a CD: stop playback APC circuit check

When stop a CD: Laser current measure

display “READING” (blink) Focus search waveform check

continuous laser diode on Tracking balance check

continuous focus search (not made focus on)

X Pause, Tracking servo off

(ignore CLV error)

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 71 72

Pas de commentaire

Aiwa JAX-S5 Manuel de service Page 18