Aiwa NSX-AJ20 Manuel de service télécharger pdf (Page 48)

1-3-25

2AV/X

1-31-3

Figure 1-3-25

Figure 1-3-26

1-3-6 Installing the drawer heater (option)

Drawer heater installation requires the following parts:

For 120 V specifications

Drawer heater set (P/N 3A569710)

Contents of the set

• One (1) BVM4 × 4 bronze binding screw (P/N B1304040)

• Two (2) BVM4 × 6 bronze binding screws (P/N B1304060)

• Clamp (P/N M2105030)

• Band (P/N M2607010)

• High temperature caution sticker (P/N 20305130)

• Drawer heater wire (P/N 3A568010)

• Drawer heater (P/N 34860030)

For 220-240 V specifications

Drawer heater set (P/N 3A569720)

Contents of the set

• One (1) BVM4 × 4 bronze binding screw (P/N B1304040)

• Two (2) BVM4 × 6 bronze binding screws (P/N B1304060)

• Clamp (P/N M2105030)

• Band (P/N M2607010)

• High temperature caution sticker (P/N 20305130)

• Drawer heater wire (P/N 3A568010)

• Drawer heater (P/N 34860020)

Procedure

1. Remove the two screws holding the rear cover of the

optional drawer and then the cover.

2. Pull the drawer out.

3. Pass the connector of the drawer heater through the

cable hole in the rear base and fit the drawer heater

using the two BVM4 × 06 bronze binding screws.

4. Fasten the drawer heater cable with the clamp using

the BVM4 × 04 bronze binding screw.

5. Affix the high temperature caution sticker.

6. Fold the cable that was passed through the cable

hole in three and tidy it up using the band.

BVM4 × 6 screws

BVM4 × 4 screw

Clamp

High temperature

caution sticker

Band

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 297 298

Commentaires sur ces manuels

Pas de commentaire

Aiwa NSX-AJ20 Manuel de service Page 48

Commentaires sur ces manuels